Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing


Reply

problem with bolt cocking piece pin

 
LinkBack Thread Tools Display Modes
  #8  
Old 10-23-2008, 11:06 AM
Silver Member
 
Join Date: Dec 2007
Location: Youngsville, NC
Posts: 390
Better solution

Remove the main bolt screw, turn 3/16" off the threads. then drill and ream the screw so it can be tapped .250 X 28tpi. Insert a .250 X 28 tpi X .750 cone point set screw inside the main screw.

Make a small shouldered cap for the cocking piece sleeve. Center drill a small dimple in this cap. Insert the cap in the cocking piece sleeve. Then screw the main screw into the back of the bolt. You can adjust externally the spring tension on your firing pin spring with a 1/8" allen wrench through the existing allen hole in the main screw. The cone point reduces the friction and make cocking much easier. This tackles to problems at the same time.
Rustystud
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes


Similar Threads for: problem with bolt cocking piece pin
Thread Thread Starter Forum Replies Last Post
bent cocking piece SAPPER26 Gunsmithing 1 06-12-2011 10:48 PM
Broke my Gentry cocking piece? elmerdeer Gunsmithing 3 06-24-2010 04:14 AM
Bolt problem HTG Rifles, Bullets, Barrels & Ballistics 6 09-01-2009 01:53 AM
Mauser cocking piece eddybo Gunsmithing 6 07-24-2009 05:48 PM
one piece picatinny rail for Browning A-Bolt Skidly_50 Long Range Scopes and Other Optics 8 01-01-2005 09:50 PM


All times are GMT -5. The time now is 03:42 PM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC