close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing

Reply

o3 Remington Bolt Handle?

LinkBack Thread Tools Display Modes
  #1  
Unread 01-01-2010, 09:22 PM
kc kc is offline
Gold Member
 
Join Date: Jan 2003
Location: Swartz creek Mi
Posts: 972
o3 Remington Bolt Handle?

I have just about finished my winter project, I have been working on an 03Remington,
I have been hiting the Gunshows and buying Reievers that meet spec and only the ones over 800,000..! I would like to choose a bolt handle, I love the one on Rugers, should I tig weld the bolt on or Silver Solder.?
and if you chose a Bold Handle what would you shoose?
I know its my choice, but I an sure you have seen a few Springfields that you would change a few things. This Rifle is all tricked out..Jeweled.Timiny, broughton Barrel, the stock is almost the same on the Remington 700s any points you would (could)make would be nice.
Keith.
__________________
Keith Sage.
Reply With Quote
  •   #2  
    Unread 01-02-2010, 12:13 PM
    Gold Member
     
    Join Date: Jan 2007
    Location: South Dakota
    Posts: 753
    Re: o3 Remington Bolt Handle?

    TIG is the only way to go IMO.

    Just use a little common sense with your heat and you'll be fine. The only thing your concerned about in the back half of the bolt is goofing up the threads for the shroud and making the helical cam for the cocking piece soft. I made a burnishing tool that helps to buff work harden the cam so that the cocking piece runs a bit smoother during bolt rotation.

    Solder gets the job done but I have repaired quite few remmy's over the years that have had the handle fly off the bolt during a sticky case extraction.

    Good luck.

    C
    __________________
    Chad Dixon
    Reply With Quote

      #3  
    Unread 02-14-2010, 12:15 PM
    Silver Member
     
    Join Date: Dec 2007
    Posts: 297
    Re: o3 Remington Bolt Handle?

    I need some help here chad I think you were in on this 1. I cant find the thread. This is what I got going on I got 721 and a 700 on the 700 I need the parts from 721 to make it a locking bolt the gun smith I had it at was sold out. were can I find them?
    Reply With Quote
    Reply

    Bookmarks

    Thread Tools
    Display Modes


    Similar Threads for: o3 Remington Bolt Handle?
    Thread Thread Starter Forum Replies Last Post
    XP bolt handle Buffalobob Specialty Handgun Hunting 3 02-28-2010 03:35 PM
    700 bolt handle cola8d8 Rifles, Bullets, Barrels & Ballistics 4 05-22-2009 07:38 PM
    Remington bolt handle failure mdrewel Long Range Hunting & Shooting 10 11-06-2006 08:26 AM
    Bolt handle change Pat B. Equipment Discussions 4 02-09-2006 12:01 PM
    REMINGTON M-700 BOLT HANDLE SEPARATION (As in Falling Off!) Ian M General Discussion 14 01-28-2005 04:02 PM


    All times are GMT -5. The time now is 03:11 PM.


    Powered by vBulletin ©2000 - 2016, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC