Re: Converting Right hand stock to left??
Yes, I used acraglass gel. Rough up the old bolt cut-out with a dremmel and then cut or drill some little notches in the cut-out to add a mechanicam lock/ the gel works good because it stays where you put it. Acetone the area for the epoxy and make sure the paint is removed from the area of adheision. I build it up and after it cures rough it down with a small file and then finish with sand paper backed on a file. The port releif, and saftey cut, can be filled as well. recut the new openings as needed, and paint.
This is for fiberglass or composite stocks,
Last edited by Coyboy; 02-20-2010 at 07:06 AM..