Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing


chamber reamer drawings

LinkBack Thread Tools Display Modes
Unread 07-25-2010, 08:16 PM
Silver Member
Join Date: Apr 2007
Location: Fort Morgan, Colorado
Posts: 401
Re: chamber reamer drawings

I have loaded for and messed with three different brand 300WSM. A Browning A-bolt, a Tikka T3, and a Savage that I don't recall the model no. Every one of them had a tight chamber, and I seriously believe this is the nature of the cartridge. These WSM's are high pressure rounds and if I were you I would be very careful trying to encroach the lands too much. All the above mentioned rifles were handloaded using 165 grain Hornady boattail bullets.
Reply With Quote
  • Reply


    Thread Tools
    Display Modes

    Similar Threads for: chamber reamer drawings
    Thread Thread Starter Forum Replies Last Post
    FS: 6mm-06 Chamber reamer HighWall Gun Parts - Stocks, Barrels, Actions, etc. 1 12-17-2012 10:50 PM
    Chamber reamer for 7mm/.300 RCM TBerkhouse Reloading Equipment and Components 1 12-22-2011 10:25 AM
    Will a 338 RUM reamer clean out a 338 WSM chamber? sambo3006 Gunsmithing 3 03-30-2011 12:48 PM
    Chamber Reamer Nieko Gunsmithing 8 03-15-2011 07:02 AM
    257Ackley chamber/reamer drawings? MagnumManiac Gunsmithing 0 07-08-2009 06:17 PM

    All times are GMT -5. The time now is 10:35 AM.

    Powered by vBulletin ©2000 - 2017, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC