Adams & Bennett barrel

[specweldtom]

It is still in the box, 24", crowned, pre-threaded for large ring Mauser, short chambered, varmint weight. Does anybody know if they are good quality, cut or button rifled? I don't have any particular use for it, but who knows???

I called Adams & Bennett, but they said they only make 10-22 barrels, and no one there knew anything about this one. It's not going anywhere, so I have some time before I decide if I want to get it.

Any info appreciated. I'll probably post on 6BR too.

Thanks, Tom

[geargrinder]

Originally Posted by specweldtom

It is still in the box, 24", crowned, pre-threaded for large ring Mauser, short chambered, varmint weight. Does anybody know if they are good quality, cut or button rifled? I don't have any particular use for it, but who knows???

I called Adams & Bennett, but they said they only make 10-22 barrels, and no one there knew anything about this one. It's not going anywhere, so I have some time before I decide if I want to get it.

Any info appreciated. I'll probably post on 6BR too.

Thanks, Tom

They are not bad barrels. They are cheap barrels. They are about on par with average factory barrels. They are button rifled.

I have one for my Savage in 22-250AI- 14"twis. It will shoot 1/2" without much load development. I just use it for fireforming for my 8" twist Douglas barrel.

[AlbertaAl]

I had one in a 20TAC 1:12 and it was every bit as accurate as the PacNors I also own.

[specweldtom]

Thanks very much for the info. The replies on 6BR were mixed too.

Good hunting, Tom