close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Gunsmithing

Reply

7mm Ultra freebore

LinkBack Thread Tools Display Modes
  #1  
Unread 06-06-2009, 01:31 PM
Silver Member
 
Join Date: Mar 2008
Location: PA
Posts: 401
7mm Ultra freebore

Can anyone tell me what the standard freebore is on the 7mm RUM? I purchased a PTG reamer and it has .400 freebore. I can set a 168 berger in a resized case carefully close the bolt and not push the bullet into the lands or in the case. Do I have to order a reamer with a shorter throat or do different makers have diff. specs? Thanks
Reply With Quote
  •   #2  
    Unread 06-06-2009, 07:50 PM
    Platinum Member
     
    Join Date: Jan 2005
    Location: OK
    Posts: 2,133
    Re: 7mm Ultra freebore

    Frank, Send the reamer back to Dave for a match regrind, and spec out your neck diameter .003"-.004" over loaded neck dia. with a lead dia. of .2845". Then give him a free-bore or lead length that will work with what your doing. If your measuring a dummie round, from case neck to end of bearing surface, minus about .040". 1-30 taper or less.
    Reply With Quote

    Reply

    Bookmarks

    Thread Tools
    Display Modes


    Similar Threads for: 7mm Ultra freebore
    Thread Thread Starter Forum Replies Last Post
    284 Win Freebore heikki02003 Rifles, Bullets, Barrels & Ballistics 0 01-27-2009 03:52 PM
    Too much freebore? wadevb1 Gunsmithing 4 06-22-2008 10:24 PM
    Freebore TMR Rifles, Bullets, Barrels & Ballistics 5 11-27-2006 11:57 PM
    338 RUM Freebore royinidaho Rifles, Bullets, Barrels & Ballistics 3 02-19-2006 06:53 PM
    Considering .300 Wby without freebore Delta Hunter Rifles, Bullets, Barrels & Ballistics 4 02-27-2002 12:08 AM


    All times are GMT -5. The time now is 09:08 PM.


    Powered by vBulletin ©2000 - 2017, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC