Originally Posted by chino034
A.J. did you have to adjust your dies any to get the same sizing and seating depth on the hand press as your bench press. I have been looking hard at these presses too. Thanks
Yes, I had to back them off about .20" or so, I think I am going to make a shim and have a buddy surface grind it to the exact thickness, then my dies won't need readjusted. If you only load for one caliber, you could just get a second seating die.
Every press I have is a little different in that perspective.
If some is good and more is better, then too much is just right.
My mind is a raging torrent, flooded with rivulets of thought, cascading into a waterfall of creative alternatives
Last edited by AJ Peacock; 12-23-2007 at 11:34 AM.