Load data for 6.5/25WSSM

[dwm]

Barrel is on order and I have some cases prep'd.

I am going to start with 130 Accubonds and 140 Berger VLDs.

Any suggestion on how much H4350 I should start with?

Thanks,

Doug

[Mikecr]

I shoot 139Lapuas, and have 130Normas to try one of these days.
I use 47.4IMR 4350(which is not the same as H4350).

I believe 260 loads would be closest to reference, as the case capacity is pretty close.

[winmagman]

I believe 260 loads would be closest to reference, as the case capacity is pretty close

That's good advice, I started there when I was working up loads for mine. I'm not using H4350, probably should be as I think the Re 22 I'm using is a tad to slow.

Chris

[dwm]

Thanks,

Would H4831SC would be a better choice?

I have some of that too ...

[winmagman]

If I were starting over again I'd go with the H4350. Not that the 4831 won't work (I have some just haven't tried it since its fairly close to Re 22) but I think a little quicker burn rate would be better. Just my unproven opinion though.

Chris

[RockZ]

I am using 130VLD's and H4350.

My most accurate load is: 45.9gr@2.642OAL no pressure signs at all.