Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Reloading

Reloading Techniques For Reloading


Reply

Killed my die

 
LinkBack Thread Tools Display Modes
  #15  
Old 06-27-2011, 03:03 PM
Platinum Member
 
Join Date: Jun 2010
Location: greenwood, IN
Posts: 3,604
Re: Killed my die

Quote:
Originally Posted by B-RAD View Post
Hornady One Shot spray lube will save you life, but as for the stuck case, I had 2 so far and they were before One Shot - Anyways you can get them out with some "redneck engineering", you can send them to your dies manufacturere aswell, and they also make stuck case removal tools.

If there is a lip left over on the brass you can grab it with linesmans pliers and just twist it up and the brass should end up tearing into a spiral and come out, or you can soak in it Kroil for a day or two then go back at it with something.

I also just found a bolt that would forcefully screw into the brass making threads along the way (the head was torn off from the jaws of my CO-AX) and then put a socket over the die that would let the brass come out into the cavity of the socket and yet let me tighten the bolt, basically when I was done the brass was inside of the socket and came out with a few turns... very easy

Oh and I polished my dies since then with a drill and some JB Bore Brite.... never had an issue since... with one shot lube of course
not knowing what caliber you using, you can drill a .250" hole thru the primer pocket. Then get a 1/4-28 all cap screw that is about an inch or so long. Turn the head down to where it will pass thru the neck. Install the die as usual in the Co-Ax, and bring the bottom slide up close to the die body. Thread the bolt into the 1/4-28 threaded hole for the spent primers, and pull the case out on the down stroke of the press. You can also do the same thing without drill a hole in the case body by using a vise and a pipe union. Just turn the bolt head till it slips into the case body, and push it out in the vise. Put the pipe nipple between the die and the case so it will pass thru the pipe union.
gary
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes


Similar Threads for: Killed my die
Thread Thread Starter Forum Replies Last Post
8 Big Horn Sheep Killed FEENIX General Discussion 30 01-20-2010 08:38 PM
4 stands, 3 called, 2 killed Arky Coyote Hunting - From 10 Yards to over 1,000 Yards 3 09-30-2008 01:51 PM
Did the laser RF killed the MilDot ?? Gustavo Long Range Scopes and Other Optics 15 03-17-2006 10:06 AM
killed my buck with the 125g ULD remingtonman_25_06 Long Range Hunting & Shooting 4 10-22-2005 11:38 AM
One of our own killed in Iraq Randy in Va General Discussion 13 04-29-2004 09:42 AM


All times are GMT -5. The time now is 11:47 PM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC