Re: Dies for 338 edge?
I believe the shoulder junction would be too small using an unmodified 300RUM die. You would need to machine that point to make it work. I believe this modification is what Shawn Carlock does. I have a set of bushing dies from Shawn and they work very well.
I recently purchased a Lee Neck Collet die set for the 338 Edge but have not had a chance to play with it yet. That die set was $55 and took 6 weeks for the custom die. I sent them 2 fired brass and 2 300gr SMK's and recieved the collet neck die and a seating die.
If some is good and more is better, then too much is just right.
My mind is a raging torrent, flooded with rivulets of thought, cascading into a waterfall of creative alternatives