Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Reloading

Reloading Berger Bullets


CH 4D cannelure tool, anybody use one?

LinkBack Thread Tools Display Modes
Unread 12-08-2012, 09:28 PM
Gold Member
Join Date: May 2004
Location: Alaska
Posts: 985
CH 4D cannelure tool, anybody use one?

Just checking to see if anybody uses one of these,
Do they work as claimed by Ch4D ?


my .375 wildcat was designed to seat the bullets .200" out past the bottom edge of the existing cannelure on the 300 gr Accubond bullet resulting in only the boat tail of the bullet seating past the neck maximizing case capacity,

BUT, now I am concerned about recoil and bullet movement in the cartridges in the detachable magazine,
any thoughts on this cannelure tool , or taper crimp, roll crimp etc. on the bullet ?

Last edited by Swamplord; 12-08-2012 at 09:29 PM. Reason: info
Reply With Quote



Thread Tools
Display Modes

Similar Threads for: CH 4D cannelure tool, anybody use one?
Thread Thread Starter Forum Replies Last Post
cannelure bigry26 Reloading 1 12-05-2012 09:02 PM
.223 Hor. SP Cannelure @ 3100 load 13point Reloading 1 12-17-2011 07:56 PM
C - H cannelure tool specweldtom Reloading 0 10-05-2010 02:20 PM
Reloading Tool & Accessory Tool box Chas1 Equipment Discussions 9 01-18-2010 04:30 PM
180 gr Partition w/cannelure brokenspoke Reloading 1 08-31-2009 09:22 PM

All times are GMT -5. The time now is 05:31 PM.

All content ©2010-2015 Long Range Hunting, LLC