Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Reloading

Reloading Berger Bullets


338 edge problem

LinkBack Thread Tools Display Modes
Unread 02-06-2013, 01:37 PM
Silver Member
Join Date: Jun 2010
Posts: 194
Re: 338 edge problem

Make sure that the crimp on the seater die does not reform the case when seating the bullet. This can happen when it is turned into the press too low. Setup the seater die by taking the case to the top of the press. Then screw the seater die in until it get stuck against the case neck. The turn the seater die out at least two full turns. This will prevent the seater die to crimp the case neck.
Reply With Quote



Thread Tools
Display Modes

All times are GMT -5. The time now is 11:37 PM.

Powered by vBulletin ©2000 - 2015, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC