Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Reloading

Reloading Techniques For Reloading


Reply

338 EDGE first test loads

 
LinkBack Thread Tools Display Modes
  #1  
Old 04-01-2009, 03:59 AM
Platinum Member
 
Join Date: Nov 2008
Posts: 1,063
338 EDGE first test loads

I am making up some 338 EDGE loads for the first time.

I started with new Remington RUM brass then uniformed the Primer pockets and flashholes. I then and run them through a K & M mandrel to expand them to .338 cal and then neck turned them to .366"

These cases look ready to load but do I need to now run them through a .338 EDGE FLS die?

These cases are only to run the barrel in so I would like get away without Full length sizing them?
__________________
scientia est potentia
Reply With Quote
  #2  
Old 04-01-2009, 05:01 AM
Platinum Member
 
Join Date: Oct 2005
Location: Michigan
Posts: 2,232
Re: 338 EDGE first test loads

If the brass will cycle in your rifle and will hold a bullet (tight enough), then you should be good to go.

AJ
__________________
If some is good and more is better, then too much is just right.


My mind is a raging torrent, flooded with rivulets of thought, cascading into a waterfall of creative alternatives
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes


Similar Threads for: 338 EDGE first test loads
Thread Thread Starter Forum Replies Last Post
250 gr ab or pt loads for 338 edge bubba41 Long Range Hunting & Shooting 0 07-10-2011 09:16 AM
loads for 338 edge bubba41 Long Range Hunting & Shooting 3 03-20-2011 03:18 PM
Loads for 338 edge nddodd Reloading 8 02-06-2009 03:23 AM
.338 Edge loads soren Reloading 9 04-12-2008 10:55 PM
Best way to test loads? Blacktail Reloading 10 09-26-2006 11:08 PM


All times are GMT -5. The time now is 06:40 AM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC