Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Reloading

Reloading Techniques For Reloading


Reply

30-06 to 280rem

 
LinkBack Thread Tools Display Modes
  #1  
Old 02-23-2008, 10:24 AM
Junior Member
 
Join Date: Feb 2008
Location: Eastern Iowa
Posts: 25
30-06 to 280rem

i have a stock 280rem and i would like to use better brass than the winchester and remington brass avilible but dont want to pay the excessive amount for the norma brass so i was wondering if it would be possible to make 280rem brass out of lapua 30-06 brass and if so what steps would nedd to be taken.
Thanks
PFC Skoug
__________________
Nathan Skoug
Gunsmithing Student
Trinidad State Junior College
Reply With Quote
  #2  
Old 02-23-2008, 12:37 PM
Platinum Member
 
Join Date: Jul 2002
Posts: 2,856
It can be made from 30-06 but the end result will be case with a slightly shorter neck. All thats needed is to nun the 30-06 brass through the 280 die and whats gonn ahppen is that your going to end up with a 280 case that is slightly shorter at the shoulder neck line and have a funky looking neck. This neck is going to act like a false shoulder so that theirs not an bad trouble with the excessive headspace that would be their if you sized the whole neck. Shoot the heaviest bullet possible and cheap with a mild mid range load for it. that will blow the shoulder forward and fully form the case.
You can also size the entire neck of the case and seat the bullet out far enough that it is jammed into the lands hard this will hold the case in place when its fired. again use a very long heavy bullet with a mid range load.

Or you can use the 280 brass from Nosler , its sadi to be pretty well built , and out of a factory gun I woulden't be worrying to much about how consistant the brass is as the factroy barrel likely isin't good enough to take advantage of the extra cost and consistancy of the higher quality brass.

Not that I'm knocking your equiptment but typicaly sorting the brass for tight consistancy is one of the later steps for better accuracy. Although the Lapua brass is very tough and will last a long time compaired to Rem and Winchester
__________________
Si Vis Pacem Parabellum
Molon Labe
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes


Similar Threads for: 30-06 to 280rem
Thread Thread Starter Forum Replies Last Post
Primers for .280Rem? meatyrem Reloading 6 01-31-2011 12:17 AM
Looking for 280Rem data meatyrem Reloading 4 12-04-2010 12:06 AM
Are there any negatives to fireforming factory .280Rem in a .280AI Chamber? Troutslayer2 Reloading 4 07-25-2010 07:39 AM
Starter Load for 300wm and 280rem DoubleGobble00 Reloading 2 07-03-2009 10:23 AM
rate of twist for 280Rem trebark Rifles, Bullets, Barrels and Ballistics 1 01-17-2008 09:32 PM

Current Poll
Do You Think Slingshots Should Be Legalized For Hunting Brown Bear?
Yes - 47.14%
907 Votes
No - 52.86%
1,017 Vote
Total Votes: 1,924
You may not vote on this poll.

All times are GMT -5. The time now is 12:36 AM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC