Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Equipment Discussions


Hollywood Press Dismantling

LinkBack Thread Tools Display Modes
Unread 01-16-2010, 11:07 AM
Junior Member
Join Date: Jan 2010
Location: NM
Posts: 3
Hollywood Press Dismantling

After much aggravation & surface damaging I've surrendered to the "I can't figure this one out" position. I need some guidance! I've got 2 Hollywood Standard Presses that were as grungy as could be. I took apart what would willingly come apart, leaving just the handle & the pivoting steel cylindrical piece intact. I did remove the pin inside the cylindrical part. I soaked it in an anti-rust solution for 4 hrs., then applied my macho "watch me scratch this handle real well with this pipe wrench" idea. Then took it to a guy with a torch to apply HEAT (only on the cyl.) & PULL idea. I can dress the handle back to a recognizable condition, but I've still got "the grunge". ANY IDEAS OR SOLUTIONS ARE MUCH APPRECIATED.
Reply With Quote



Thread Tools
Display Modes

Similar Threads for: Hollywood Press Dismantling
Thread Thread Starter Forum Replies Last Post
WTB: Hollywood Universal Turret Kevin Rohrer Reloading Equipment and Components 9 07-21-2011 11:24 AM
WTB: Hollywood Universal Press Kevin Rohrer Reloading Equipment and Components 0 10-19-2010 08:24 PM
Dismantling my Computer setup royinidaho General Discussion 17 09-08-2010 02:08 AM
Hollywood Bullet Swaging Dies/Jackets for Sale lkydvl Reloading Equipment and Components 0 02-21-2010 03:45 PM
Need a god press Akkill Reloading 10 10-21-2009 12:20 PM

All times are GMT -5. The time now is 04:45 PM.

Powered by vBulletin ©2000 - 2015, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2015 Long Range Hunting, LLC