close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Chatting and General Stuff > General Discussion

General Discussion Must wear red or OD green socks to participate. I can't see your socks, please be honest.

Reply

coating my savage barrel and receiver installed

LinkBack Thread Tools Display Modes
  #1  
Unread 02-18-2013, 08:27 PM
Junior Member
 
Join Date: Dec 2012
Posts: 24
coating my savage barrel and receiver installed

What is the best method of getting a barrel and receiver ceracoted? Would it be best to disassemble the barrel/ nut/receiver or could I get by with doing it all assembled? I suppose the only issue I would have if coating it assembled would be being able to remove the nut later for rebarrel. Actually what I am getting is a coating from Polydyne in Houston, but it's similar to ceracote.
Reply With Quote
  •   #2  
    Unread 02-19-2013, 01:35 AM
    Platinum Member
     
    Join Date: Apr 2012
    Location: The cold part of Montana
    Posts: 1,391
    Re: coating my savage barrel and receiver installed

    paint it up and don't worry about it, tough as that stuff is it can be removed
    __________________
    Keep in mind the animals we shoot for food and display are not bullet proof. Contrary to popular belief, they bleed and die just like they did a hundred years ago. Being competent with a given rifle is far more important than impressive ballistics and poor shootability. High velocity misses never put a steak in the freezer.

    Joe
    Reply With Quote

    Reply

    Bookmarks

    Thread Tools
    Display Modes



    All times are GMT -5. The time now is 04:35 AM.


    Powered by vBulletin ©2000 - 2017, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC