Case mouth deburring

Varmint Hunter · #1 02-27-2004, 01:21 PM

I am prepping some new Lapua 6.5x284 cases. Necks have been turned and I am about to give a slight bevel to the inside of the case mouths. Should I use the standard RCBS deburring tool or should I use the Lyman VLD deburring tool which has a much steeper angle?
Initially, I will be working with Sierra 142gr HPBT's and Hornady 140gr A-Max bullets.

VH

LDO · #2 02-27-2004, 01:43 PM

personally i would use the vld tool-my-2-dave

BountyHunter · #3 02-27-2004, 02:23 PM

Daryl Holland makes a great VLD tool that is only $23 and is super fast and smooth using 14 degree cutting head for VLDs.
www.hollandguns.com

BH

Brian Rybicky · #4 02-27-2004, 02:30 PM

VH,

I deburred some 6.5/284 with the standard rcbs an i had to pull some loads because they were to hot, the base right near the boattail was all scruffed up, I loaded a few of them up and shot a .26 at 100yd but they were very inconsistant at 800yd.