Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Rifles, Bullets, Barrels & Ballistics

Rifles, Bullets, Barrels & Ballistics Applied Ballistics


rem mag feed rails

LinkBack Thread Tools Display Modes
Unread 03-19-2004, 11:03 PM
Bronze Member
Join Date: Feb 2004
Location: wisconsin
Posts: 40
rem mag feed rails

are the feed rails on the 7rem mag the same as the 300 rum and 300 tomahawk?
Reply With Quote

Unread 03-19-2004, 11:31 PM
Junior Member
Join Date: Feb 2004
Location: pa
Posts: 1
Re: rem mag feed rails

i hvae talked to hart rifles and they tell me that they will need opened.it only takes a little work and i was told if they chamber for you there is no charge for this
Reply With Quote
Unread 03-20-2004, 03:35 PM
Silver Member
Join Date: Oct 2002
Posts: 328
Re: rem mag feed rails

.. On my Winchester WSM the feed rails are not big enough to feed the WSM cartridges thru.. But it's set up as a single shot so it doesn't really matter.. If I try to lay a cartridge in too far back in the port the rails tend to "grab" the brass.. I think the amount the rails need to be opened is pretty small and would not amount to much of a difference in the action strength..
.. On the negative side, and this is based on theory, I think if you do this modification the action probably will not work with "standard" mag cases anymore.. d:^) JiNC
Reply With Quote


Thread Tools
Display Modes

Similar Threads for: rem mag feed rails
Thread Thread Starter Forum Replies Last Post
Opening up Feed Rails on a Remington model 700 williamsc31 Rifles, Bullets, Barrels & Ballistics 11 07-07-2011 06:14 AM
savage 200 convert center feed mag to stagered feed jeb20208 Gunsmithing 4 10-27-2010 11:23 PM
Controlled round feed vs push feed. RockyMtnMT Rifles, Bullets, Barrels & Ballistics 8 02-05-2009 05:03 PM
Opening up M700 feed rails? ceg1963 Rifles, Bullets, Barrels & Ballistics 3 04-29-2006 12:09 PM
Winchester mod 70 Push feed vs Controlled round feed? samson Rifles, Bullets, Barrels & Ballistics 4 02-13-2006 08:10 AM

All times are GMT -5. The time now is 03:54 PM.

All content ©2010-2015 Long Range Hunting, LLC