Long Range Hunting Online Magazine

Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Rifles, Bullets, Barrels & Ballistics

Rifles, Bullets, Barrels & Ballistics Applied Ballistics


Recoil Lug

LinkBack Thread Tools Display Modes
Unread 11-07-2013, 04:41 PM
Bronze Member
Join Date: Mar 2011
Location: Shippensburg Pa
Posts: 91
Recoil Lug

I am putting a new barrel on my savage lrh my question is the new recoil lug is thicker than the old one and wider it will not fit in the lug channel. Taking off factory barrel putting on a savage bull 1.06 at the breech and 1.00 at muzzle.
First one I am going to do myself any suggestions would be helpful.
Thank You
Dirk (bigdumboy)Kissinger
Reply With Quote

Unread 11-07-2013, 06:14 PM
Platinum Member
Join Date: Oct 2008
Location: Alabama
Posts: 7,828
Re: Recoil Lug

Take a dremel tool with a sander bit and open up the lug channel ever so slightly. Then see if it will fit. Continue till it drops right in and fits snug with little wiggle room. If you overbore the channel too much, you will want to bed the lug with devcon to be sure it seats snugly when you tighten down your action screws so the action is secure and doesn't move during recoil when shooting.
"I'm just a peckerwood who lives in the hills with too many guns..." - Bob Lee Swagger

"Give me a minute...I'm good. Give me an hour...I'm great. Give me 6 months...And I'm unbeatable." - Col. Hannibal Smith

Ignore everything I say, because I have a reading comprehension and memory problem...

Originally Posted by WildRose View Post
The 284 is to the STW what a tricycle is to a Ninja.
Reply With Quote


Thread Tools
Display Modes

All times are GMT -5. The time now is 05:41 PM.

Powered by vBulletin ©2000 - 2015, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2015 Long Range Hunting, LLC