Re: Contact info for Barrel Block makers
As far as making a barrel block with a 1.350 bore,you would need to order at least 5 barrel blocks as I would have to have a reamer specailY ground to that diameter.If you already have the barrel with a 1.350 bore, I would recommend a 9" barrel block with a 1.3125 bore and then turning your barrel down to 1.3125 for 9" then you would slip the barrel block onto the barrel from the breech end and then thread on the action. The barrel block width for the 1.3125 would be 1.8125. Minimum stock width I would recommend would be 2.200 (top of your forearm.) The stock in the picture is a 3-1/2" flat bottom forearm which tapers to 2-1/2" at the top. Here are some standard bore diameters if you are having a barrel made, you can specify contour to match the bore.
1.250 over all barrel block width 1.750
1.312 over all barrel block width 1.812
1.375 over all barrel block width 1.875
1.437 over all barrel block width 1.937
1.500 over all barrel block width 2.000
without God their is no hope for this country