i may have located a reamer already.. [using a remington 700 short action in 243/308 bolt face, it will arive this week], drawing of the reamer shows the wall of the case is blown out from .4716 to shoulder.461, with a 45* shoulder, .2905 dia. neck an .260 long, oal case length .2.045 seeems it was printed by pacific tool
.. [ i knew the neck would be short .260]
on the wyats box .. where can one locate such an item.. i've had know luck looking it up ? i certainly would want to have it while at the smitty,,.. i may not need it done up front, but why wait or have to send it back, the artical also show an oal loaded case at 2.830,
i don't think i would use a detachable mag. anyway.. [ it only would need one shoot... Lol's]
the 120gr bullet may get away with a one in ten tw, but if i decide later on some other factor i rather have 1-8.5 at the least a 9 [minuim 28"].. which leads to another question .. what kind of a crown or button would be best to use.. i've read resest an 11* degree, but not actually understanding the terms.. since the artical says it would have so little recoil, less then a 243 stated.. i don't think it would need to be magna ported or any attachment on the barrel...
Last edited by Olio Tutto; 11-05-2007 at 10:05 AM.