back with more elevation adj problems
i posted earlier this week about how my loads seemed to be, and were shooting a lot faster than what i had thought. well i went shooting again yesterday, and with new rem brass which has more case capacity than the federal brass i was using, i used some powder to compare. anyways i actually had less elevation adjustment to get on at 500 meters than before. with this adjustment the loads would be shooting at about 3200 fps, which there would b no way of happening. because the load is estimated at 2800 fps with a test rifle with the same length barrel. AND the brass i was using yesterday has more case capacity, primers weren't cratered and the heads looked clean no ejector marks. SO, is my scope just not tracking right? its a bushnell elite 3200 10x40 MD. any thoughts and advice would be great. thanks!