close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Rifles, Bullets, Barrels & Ballistics

Rifles, Bullets, Barrels & Ballistics Applied Ballistics

Reply

6mm rem.

LinkBack Thread Tools Display Modes
  #1  
Unread 09-06-2004, 07:18 PM
Bronze Member
 
Join Date: Sep 2004
Location: SC
Posts: 48
6mm rem.

I'am shooting remington factor load and getting very tight grups.100 grain @ 3100 FPS is what remington ballistic show.I pull the bullet off a case and the powder measured 45.5 grains..OK grains of what type of powder ? Does anyone know
THANKS SKEETER
Reply With Quote
  •   #2  
    Unread 09-06-2004, 07:50 PM
    Bronze Member
     
    Join Date: Aug 2004
    Location: Arizona Mountains
    Posts: 50
    Re: 6mm rem.

    Skeeter - Factories do not use powder that you would be able to buy. They buy in very large quantities and the powder is blended to produce the velocities and pressures they are working toward.

    I assume you are interested in duplicating the factory load because it shoots so well. What you will need to do is first chronograph the factory load to see what the actual velocity is in your rifle. It may be quite a bit different than what is advertised. Then you would have to work up a load that duplicates that velocity. I would guess that a powder similar to H4350 or H4831 is what you would have to try, to start.

    If you do not do a lot of handloading you might be better off just buying several boxes of factory loads for hunting and using handloads for plinking and other shooting.

    [ 09-06-2004: Message edited by: Cheechako ]

    [ 09-06-2004: Message edited by: Cheechako ]
    Reply With Quote

    Reply

    Bookmarks

    Thread Tools
    Display Modes



    All times are GMT -5. The time now is 12:04 AM.


    Powered by vBulletin ©2000 - 2016, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC