Originally Posted by MagMan
Chris, did you ever figure out what the problem was. I've got the same thing going on.
I Just replaced the RCBC FL die with Redding NS Die, and everything is working great.
MagMan, I did a small experiment with the FL Die:
- I setup the press to do not go up all the way. (0.25 left to be all the way up)
- I runed throug the FL die, and I notices the die is cutting from the outside neck case a small amout from the wall.
If you are going all the way down, you will never see the die is cutting from the outside wall.
This is way you and my self got all the ring residues from the dies.
Now be verry carefully because after running over and over and over the same brass on the die (10-12 time) your case will be stuck in the die because of the residue accumulation.
Be carefully to clean the die after few running.
I could not find whay I got all this marks on the neck area, so I will send back the die to rcbs after New Year to let them fix the problem.