Originally Posted by sharpshooterbr
I don't know if this could be leading to your problem, but I see two definite problems with your setup. One, on a turret press, I have found it best to always tighten the set screw in the back of the press tight up against the turret to keep flex to a minimum. I have seen some turrets flex so much as to misalign the ram and the die. Also, I noticed that you have a lot of bench flex when you are sizing, this can also lead to problems especially when performing forming operations. Just my .02 cents.
I know about the bench flex, I have to change it after New Year with a more strong one,
About the turret I already tight up the back screw.
Did you go all the way up with the back screw?
About the FL die, I decided to send it back to rcbc and I hope they could fix the problem.
In the same time I just got Redding NS Die from a local Gunsmith.
I hope this one will work.
Thank you for helping me wtih the FL DIE and also about the bench.