Re: 22 dasher
Thanks far the replies everyone. I realize I'll need a 243 bolthead, custom dies so far are going to be the hardest to locate. One person on another forum sudgested getting a 22br die and use my reamer to hog it out.
I also read that although the 22-250 ackley would be the easiest way to go that the brass by I'ts nature in that round is not very strong just above the cartridge base? I beleive one would have to check this with calipers as you reloaded to stay away from case head separation?
I would also like a round that offered the fine lapua brass, so as far as I know there is no 22-250 lapua brass,I'd have to make it from 243 or 6.5x47 perhaps? Which sounds like extra work to me.
Perhaps I should do a 22 cheetah or 22-243. I realize they wouldnt differ that much from the 22-250ai but I was after something a little more off the beaten track. I really dont care about eating the barrels or the like, I simply thought the dasher sounded like a cake and eat it too round. Thanks again,