close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Long Range Scopes and Other Optics

Long Range Scopes and Other Optics Nightforce Optics

Reply

Night Force windage knob problem. Advise please.

LinkBack Thread Tools Display Modes
  #1  
Unread 07-20-2013, 07:40 AM
Junior Member
 
Join Date: Nov 2010
Location: Mérida Yuc Mexico
Posts: 14
Night Force windage knob problem. Advise please.

Well, I have a 4.5-22 X56 NXS,Zero stop scope. After I zeroed it at 100 meters,the windage knob was at 2 MOA to the right,I decided to put it to zero,I loosened the screw,and took the knob out OF THE SCOPE,when I put it back,it did not entered completly.It was 2 lines out,I tried hard to push it back,at zero,and at 2 MOA where it used to be,but every thing was useless,so I tighten it,but it looks like it has 40 MOA of correction,and I am afraid that the gap may get dust into the scope.I can live with it,but I am really disapointe with my *mechanical hability*.
By the way I tried to take out the battery,but it is very tight and I´m afraid to use any tool. I cant send it to service,and now it is ilegal in my country to mail it abroad. Any thougts. Advise please.
Thank you for reading.
Reply With Quote
  •   #2  
    Unread 07-20-2013, 08:24 AM
    Platinum Member
     
    Join Date: Feb 2007
    Location: Townsend, Montana.
    Posts: 8,548
    Re: Night Force windage knob problem. Advise please.

    On your windage knob remove the screw completely, and pull out on the knob to remove it. Then look at the O-rings on the scope and make sure one is not out of the grove or damaged. Take your finger and rub some of the grease there over the O-rings and inside the cap. Then place it back on slowly wiggling it pushing all the way on. Once ot is on all the way replace the screw, align the zero and tighten the screw.

    For the battery, I would not use tools. But yes they are tight. Using two hands, hold the barrel of the parrelax knob with one hand and twist counter clockwise on the knob top with the other. Sometimes a piece of soft light rawhide or rubber will help you get a better grip. Do not max out the adjustment and twist against it. Do this in the middle of adjustment range so you don't damage the internals of the scope.

    Jeff
    __________________
    Reply With Quote

      #3  
    Unread 07-20-2013, 01:45 PM
    Junior Member
     
    Join Date: Nov 2010
    Location: Mérida Yuc Mexico
    Posts: 14
    Re: Night Force windage knob problem. Advise please.

    BROZ:I will try all you mentioned. Your advise is very helpfull to me.
    Thank you very much.
    Reply With Quote
    Reply

    Bookmarks

    Thread Tools
    Display Modes



    All times are GMT -5. The time now is 05:51 PM.


    Powered by vBulletin ©2000 - 2017, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC