Ivey 50 moa adjustable rings

[James D.]

Those definately look more precise than the Barrett rings... The Barrett rings are adjustable by trial and error, when compared to the Ivey rings.... a price to pay.

[texas]

Randy what type of base does these rings need?

[Randy in Va]

Texas, this should answer your questions plus pictures of other finishes.

* Adjustment with 1 MOA graduations from 0 – 50 MOA
*Models to fit Weaver type bases "MSR", Stolle-Davidson 1/2" dovetail "BR", and Anschutz 11mm dovetail "RF"
*Two point locking pivot ring system
*Precision machined matched paired sets
*High strength aluminum alloy
*Finish in Semi-matte Black hardcoat anodize or Bright coat anodize
*High strength alloy steel black or stainless bolts
*Ball point hex key wrench set included for assembly and adjustments
*Optional quick release, tool-less change over set
*Optional 1.00” bushing set
http://www.imagestation.com/picture/...7/fc2f1204.jpg
http://www.imagestation.com/picture/...e/fc2f1206.jpg
http://www.imagestation.com/picture/...0/fc2f1208.jpg

[Nicholas]

That front ring looks like it's happy to see me. [img]images/icons/grin.gif[/img] LOL

Randy

Do you know what the approximate height of the rings are? measured from the top of the scope base to the middle of the scope tube?

[ 05-09-2003: Message edited by: sr90 ]

[texas]

Randy, you are carrying some beautiful rings [img]images/icons/cool.gif[/img].

[Brent]

Randy,

Assuming they must calibrated for a certain spacing apart to be accurate, what distance is it and is it measured on center of at their maximum width apart? This would dictate what tubes would fit and what wouldn't. These are made to be used in conjunction with internal vertical scope adjustment or as a stand alone that would be more accurate?

Do they offer one that's all steel?

[ 05-10-2003: Message edited by: Brent ]

[Randy in Va]

Brent and SR90,

distance from center of 30 mm tube to top of mount is .7 inches.

Spacing of feet is set at 4 inches for short action and 4.75 for long. A different cam goes into each one to give it a 50 MOA maximum.

As to the question as to whether these were meant to be more precise than internal scope measurements.....
They may just be, but that is not the intended use. They are meant to supplement internal use for those that need major elevation changes with finer adjustments made with the scope.

This allows you to keep near the center of an internal scope no mattter what the need. Could you make a 3 moa adjustment with the micrometer, absolutely. Keep a notepad handy, though!!!!

I will post a cross section drawing of the mount in a few minutes.