Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Long Range Scopes and Other Optics

Long Range Scopes and Other Optics Nightforce Optics


Reply

I need suggestions for a more clearly identifiable LR Target.

 
LinkBack Thread Tools Display Modes
  #1  
Old 05-02-2001, 10:25 PM
PUBLISHER
 
Join Date: May 2001
Posts: 5,878
I need suggestions for a more clearly identifiable LR Target.

I need suggestions for a more clearly identifiable LR Target.
--------------------------------------------------------------------------------
We are setting up for our .408 Chey-Tac Evaluation Test. I set up a range to 2500 yds. yesterday. I used a full Redfield target with a four inch flourescent border and ten inch white border background. This has worked well for me at 1000 yds. At 2500 yds. I see a white spot and some blurry orange. It is not clear enough for accuracy. I tried a 16X Mark IV and a 8.5 x 25 Vari X III modified 2X to 17 x 50X. It does not matter as it seems on most days we will be only able to use 15-20 X due to mirage. Dean Michealis who is coming to shoot suggested trying a 1 ft black dot on white background.
What have you used succesfully at extremely long range for aimpoints? Thanks

Warren@lostriverballistic.com http://www.lostriverballistic.com

[This message was edited by Warren Jensen on April 12, 2001 at 07:57 AM.]

posted April 12, 2001 07:22 AM

Warren Jensen
Member

From: Arco, ID US
Registered: April 12, 2001
Posts: 6
No need for perfection here men.
--------------------------------------------------------------------------------
I have a few days to test out your ideas. I will get back to you with what works best.
I just need some ideas.

Warren@lostriverballistic.com http://www.lostriverballistic.com

posted April 12, 2001 09:47 AM

Steve Shelp
Member

From: NC
Registered: April 11, 2001
Posts: 7
Warren,
For competition we used either black/white or blue/white for good contrast. The blue works a lot better to see "doubles" in competition. Other than that I don't think it has any more advantage over the black. But most important to me is the "white" paper isn't white. It's more like a really light tan colored I guess you could call it. This reduces glare and gives really good contrast between the blue or black scoring rings and aiming points. I guess for a quick fix in the field I would spray paint your "white" background some off flat color, then put your aiming "black" on top.
It also just hit me that your were a military man. If you remember the target paper they used then, it's the same stuff that is being used in all 1000yd BR disiplines.

Hope this is what you were looking for.
Steve

posted April 12, 2001 09:56 AM

Dave King
Moderator

From: Damascus, MD
Registered: April 11, 2001
Posts: 13
Warren
I shoot a lot of steel targets painted white. The white shows well and I can quarter the target. Perhaps a 4 x 4 foot plywood sheet with a 1 foot black border and a white center.

The Leupold tacticals I've used had heavier reticles and that made it difficult to center on a smallish target. 500 yards using a Leupold M3LR and the reticle hides a groundhog sized object.

posted April 12, 2001 10:03 AM

Warren Jensen
Member

From: Arco, ID US
Registered: April 12, 2001
Posts: 6
Results of LR target test.
--------------------------------------------------------------------------------
We completed a test yesterday afternoon, 12th. We used two different backgrounds, white and tan, and cut out circles 21", 15", 12" and 9" in black and blue. We compared them at 2500 yds. through a 17X scope. The larger circles were all identifiable down to 12" then it became noticeably more difficult. The white seems to offer more contrast than the tan and the black circles seemed to have a very slight edge over the blue. We also tried them at closer ranges and decided to use a 1" square for more precise aiming at closer ranges.
Our choice was a 12" black circle on white background with 1" aiming squares in the middle.

Thanks for your suggestions.

Warren@lostriverballistic.com http://www.lostriverballistic.com

posted April 13, 2001 07:20 AM
__________________


Long Range Rifles, LLC - Ready To Ship

Components and assembly by LRH Sponsors
Reply With Quote
  #2  
Old 05-09-2001, 11:19 PM
Silver Member
 
Join Date: May 2001
Location: wis
Posts: 104
Re: I need suggestions for a more clearly identifiable LR Target.

Thats a long ways optics have a lot to do with it. weather to any type of haz or lots of heat are going to cause you trouble. Have at .
Reply With Quote
  #3  
Old 06-12-2001, 01:40 AM
Platinum Member
 
Join Date: Jun 2001
Location: Palmer, Alaska
Posts: 2,539
Re: I need suggestions for a more clearly identifiable LR Target.

Warren, I started useing Leopold targets, the ones with four black 2" squares at the corners with 2" of white running vertical and horizontal between them, but past 500yds I use ones I make just like them but have 6" squares and 6" wide white stripes between them. That works well out to 1000yds with my 3.5-10 Leopold. Beyond that, no idea, good luck though.
__________________
Brent Moffitt
Reply With Quote
  #4  
Old 07-18-2001, 10:27 AM
Silver Member
 
Join Date: Jul 2001
Posts: 107
Re: I need suggestions for a more clearly identifiable LR Target.

I do a fair amount of iron sight shooting at 200-300 yrds. For sighting-in purposes I have found that a blaze orange square (or circle) on a black background works quite well for iron sights. However don't know how this would work for a scope. I buy the materials from an art supply store. They have colored sheets of material that's a fairly thick cardboard substance. Stands up fairly well in the field. Additionally your light source is crucial. For ideal purposes the sun should be at your back and shining directly down on the target. The very best sighting conditions I've ever had was at night when we put a set of truck lights shining on the target. The target just comes screaming through your scope then; just don't shoot the truck.
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes


Similar Threads for: I need suggestions for a more clearly identifiable LR Target.
Thread Thread Starter Forum Replies Last Post
.223 suggestions maverick2 Rifles, Bullets, Barrels and Ballistics 11 06-02-2009 11:07 AM
Suggestions for 257 AI hank shaper Reloading 3 09-16-2008 11:21 PM
GPS suggestions 338 bruce Equipment Discussions 2 09-02-2008 10:58 PM
1000 yard target size - What size target do you shoot at ?? Down Under Hunter General Discussion 7 12-30-2007 05:46 AM
WTS Leupold VX 3 Target LR Target Scope demarpaint Guns For Sale 1 05-26-2006 04:16 AM


All times are GMT -5. The time now is 05:27 PM.


Powered by vBulletin ©2000 - 2014, Jelsoft Enterprises Ltd.
Content Management Powered by vBadvanced CMPS
All content ©2010-2014 Long Range Hunting, LLC