close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Rifles, Reloading, Optics, Equipment > Long Range Scopes and Other Optics

Long Range Scopes and Other Optics Nightforce Optics

Reply

Correct scope install process request

LinkBack Thread Tools Display Modes
  #1  
Unread 05-04-2010, 12:48 PM
Bronze Member
 
Join Date: Jul 2009
Location: Greenbrier, Arkansas
Posts: 78
Correct scope install process request

I am looking for the correct scope mount/install process as I think I have my scope mounted too far back. I have printed Shawn Carlock article on "Fitting the long range rifle" but it does not seem to cover the eye relief/parallax. My scope does not have the parallax adjust knob only the focus/diopter at the back (Trijicon 2.5-10X 56mm mil dot TR22-2G).
Thanks in advance, I am just trying to tighten up my groups by eliminating all possible faults from caused from behind the butt plate...
Mike
__________________
Michael M. Moore
N5RWH
NRA # 166336949
Reply With Quote
  •   #2  
    Unread 05-04-2010, 08:11 PM
    Gold Member
     
    Join Date: Apr 2010
    Location: NW Mt.
    Posts: 599
    Re: Correct scope install process request

    I keep adjusting and changing rings (if I missed it that bad) until I can shoulder the
    gun with eyes shut, open them and I am dead on. I use tape and rolled cardboard to
    find the ring height I want. If you can make it a natural pointing gun you will have
    less eyestrain and parallax errors. A little tunneling in many of the 4x scopes today is
    impossible to avoid on the higher powers. They are a compromised design and the
    tunneling effect is built into the scope.
    Reply With Quote

    Reply

    Bookmarks

    Thread Tools
    Display Modes


    Similar Threads for: Correct scope install process request
    Thread Thread Starter Forum Replies Last Post
    Process for choosing a gun IdahoJoe The Basics, Starting Out 11 09-01-2011 09:12 AM
    correct ring height for lowest scope mounting remingtonman_25_06 Rifles, Bullets, Barrels & Ballistics 1 04-29-2011 05:10 PM
    Determining Correct Scope Base Angle By Robert H. Thompson ADMIN Technical Articles - Discussion 6 01-16-2011 04:06 AM
    Who to install a brake? Hicks Gunsmithing 2 01-15-2011 08:34 PM
    Recoil pad install??? Help Please ICANHITHIMMAN Gunsmithing 3 01-11-2010 11:51 AM


    All times are GMT -5. The time now is 12:15 PM.


    Powered by vBulletin ©2000 - 2016, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC