close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Hunting > Long Range Hunting & Shooting

Long Range Hunting & Shooting Nightforce Optics

Reply

pdms lr204

LinkBack Thread Tools Display Modes
  #1  
Unread 10-01-2008, 09:12 PM
Bronze Member
 
Join Date: Jul 2008
Posts: 49
pdms lr204

finally got my DPMS LR-204 in and got to play with it.am having probs with denting the brass.while i was working my load and trying to find my max powder i got to about 27 gr and still no pressure signs but i noticed a small dent in the side of the case about half way down.not a big dent but a dent.i had been recording every shot and noticed that somewhere back around 25.5 grains the dent wasnt present.im new to the ar style but not really to reloading.just looking for some knowledge as to why this could be?

oh by the way.i went back and loaded five at 25.5gr varget with 32gr vmax and shot a five shot group under a half inch @100YDS,four were under .25!trigger has 10 miles of creep but okay on bench when u get used to it.
Reply With Quote
  •   #2  
    Unread 10-01-2008, 09:31 PM
    Platinum Member
     
    Join Date: Jan 2005
    Location: OK
    Posts: 2,133
    Re: pdms lr204

    I would assume the dent is happening after fireing or the pressure in the chamber should push it out. May-be just may-be the higher loads are ejecting a little harder and sending the brass into the brass deflector causing this? Pad it with some tape(a few layers) and see what happens.
    Reply With Quote

    Reply

    Bookmarks

    Thread Tools
    Display Modes


    Similar Threads for: pdms lr204
    Thread Thread Starter Forum Replies Last Post
    dpms LR204 dahunta Long Range Hunting & Shooting 7 09-08-2008 09:17 AM


    All times are GMT -5. The time now is 08:11 AM.


    Powered by vBulletin ©2000 - 2017, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC