Re: Boy, this seems like alot-opinions please
Mine works just fine. In the instructions it says after use wind it back down to it's lowest setting so the internal springs won't give out.
It is set in 10 in/lbs increments. There is a slot with a small block that travels up and down that you align with numbers printed on the outside. The instructions say to center the little block on the desired poundage line, let's say For example 30 in/lbs is what you needed. You would center the block on the 30 in/lbs line., Half of it being above and below. If you wanted 35 in/lbs you would wind the bottom of the block even with the 30 lbs. line
The local gunsmith has a nice expensive one and the Fat wrench clicked at 50 in/lbs. and his showed 52 in/lbs. so there close.
I am satisfied with mine. If nothing else, everything is at least torqued to the same poundage.
Last edited by Seven Oaks; 06-10-2009 at 07:13 PM.