With several discussions over the years on blueprinting a Remington action I would often reply with a text of how it should be done for a properly blueprinted action. This past summer I had recorded on video my set up and machining of a Remington action and bolt and I finally sat down yesterday and put a few videos together. The video is in 2 parts each about 12 minutes long. The video shows the tools and fixtures I use and shows how I dial a Remington action in true before single point re-machining the receiver face, internal locking lugs and threads. I then switch over to my bolt fixture and show how it's locking lugs and bolt face are machined true. Hope you all enjoy!!