close
Long Range Hunting Online Magazine


Go Back   Long Range Hunting Online Magazine > Hunting > PSE TAC 15/15i Crossbow Hunting Forum

Reply

Tac crank gear pin

LinkBack Thread Tools Display Modes
  #1  
Unread 11-11-2013, 08:38 AM
Silver Member
 
Join Date: Jun 2006
Location: New Jersey
Posts: 108
Tac crank gear pin

I just want to pass on a little information for everyone with the new Elite and possibly Ordnance to check for. There is a very small steel pin that goes through the crank gear and shaft that holds the gear in place. I have the Elite and Mine has fallen out twice, with the second time being yesterday. I was very lucky in the fact that both times it happened, I was inside and heard it. It's held in place with a small allen head set screw. The first time I put the pin back in and put loctite on the set screw. Obviously That didn't work so I'm not sure what to do this time.
Reply With Quote
  •   #2  
    Unread 11-11-2013, 01:20 PM
    Field Editor
     
    Join Date: Dec 2009
    Posts: 600
    Re: Tac crank gear pin

    Mike,

    PSE just announced a recall for the TAC Elites and Ordnance that have been shipped out already this year. Crossbow Recall

    The reason for the recall is to address the problem you have had. They will also check over and make adjustments to a few other items that are much less serious.
    __________________
    Andy Backus
    Field Editor
    LongRangeHunting.com


    Reply With Quote

    Reply

    Bookmarks

    Thread Tools
    Display Modes



    All times are GMT -5. The time now is 04:36 PM.


    Powered by vBulletin ©2000 - 2017, Jelsoft Enterprises Ltd.
    Content Management Powered by vBadvanced CMPS
    All content ©2010-2015 Long Range Hunting, LLC