Originally Posted by rmbeach
My question is......will the spine of each section of the arrow be located at the same angle along the length of the shaft? I.E. could the front section be at 0 degrees, the thicker middle section be at some other angle, say 60 degrees from the 0 degree spine of the front section and then the rear section be at some other angle, say 130 degrees from the 0 degree spine of the front section?
I get where you are going, but from the testing I have done so far, I believe the spine will be at the same angle down the shaft. What I think is at issue is finding the best (being easy, accurate, and repeatable
) method of during the shaft's weakest (or strongest
) spine side (or angle position
Sorry to report, but I have not had the time to play with capturing an arrow just as it is shoved forward by the string to see if it bends on the same side as indicated from spine testing.